To enable the DWG Block Attribute population functionality, you must first download this file (IsogenDWGBlockAttributes.zip) from SmartSupport.

  1. Login to SmartSupport - https://crmweb.intergraph.com/

  2. Go to the View Downloads tab (if not already there)  

  3. Click on CADWorx Plant under Product Support Pages  

  4. Click on Freeware Tools and Utilities  

  5. Expand Isogen DWG Attribute Link Extension

  6. Click on the    icon next to Isogen DWG Attribute Link Extension

Next, Unblock and unzip the download into the {CADWorx Installation Path}\Plant\Isogen\I-Configure\ISOGEN Configuration\ folder location

17IC_AttMappingTeighaLocation.png

Follow the steps found in the Backing Sheet Data section of this file:

C:\CADWorx 2017\Plant\Isogen\I-Configure\ISOGEN Configuration\resdlls\0009\IsometricDrawingOptionsReferenceGuide.pdf

17IC_AttMapping03.png



Fill out any necessary data defined either in the ISOGENPROJECTDATASETUP or your Pipeline Attribute CSV file.

Finally, run your iso to see the data that was assigned.