When exporting out a Bill of Materials in CADWorx with the BOMEXPORT command, the LENGTH column may show a decimal number instead of properly being formatted into ft-in, like shown:

ITEM QTY SIZE DESCRIPTION LENGTH
1 1 12" PIPE, SCH STD, ASTM A106 GR B 24.0000
2 1 3" PIPE, SCH STD, ASTM A106 GR B 39.8556
3 1 8" PIPE, SCH STD, ASTM A106 GR B 12.0000


To modify the LENGTH column into a ft-in format, perform the following.


1. In CADWorx, type the command -DIMLUNIT, and press ENTER.   Then type 4 and press enter.


Now when you use the BOMEXPORT command, the LENGTH column will show up like this:

ITEM QTY SIZE DESCRIPTION LENGTH
1 1 12" PIPE, SCH STD, ASTM A106 GR B 2'
2 1 3" PIPE, SCH STD, ASTM A106 GR B 3'-3 7/8"
3 1 8" PIPE, SCH STD, ASTM A106 GR B 1'