After installing/updating CADWorx PLANT Professional, the pull-down menu is not visible.  

Perform one of the following procedures:


To re-load the “Plant” menu from CADWorx Plant Professional, run the command “LOADMENUPLANT”

The following should be seen in the command window:

  • Command: LOADMENUPLANT
  • English.dic Language file loaded…
  • Customization file loaded successfully. Customization Group: PIPE_ALT
  • Customization file loaded successfully. Customization Group: PIPE_FLY
  • Customization file loaded successfully. Customization Group: PIPE_RIB

To re-load the “Equipment” menu from CADWorx Equipment, run the command “LOADMENUEQUIP”

The following should be seen in the command window:

  • Command: LOADMENUEQUIP
  • English.dic Language file loaded…
  • Customization file loaded successfully. Customization Group: EQUIPMENT_ALT

 

If the palettes still are not showing you can run the SHOWPALETTES command. This command usually forces all palettes onto a single screen to be visible.

If your menubar is not showing use the variable MENUBAR and set it to 1

If your Ribbons are not showing use the command RIBBON