While publishing CADWorx plant components, sometimes you may notice the published graphics show up with far too many lines.  The best system variables to set for publishing are the following:


Set the following:


  1. dispsilh 1 
  2. isolines 0 
  3. make sure your mview is in legacy hidden mode



George Montgomery, EIT 

Technical Support Manager

support.ecedesign.com

P 713.623.1502 C 832.993.8095


Important Disclaimer: All design information provided is for software support and informational purposes only. ECE Design takes no responsibility without written authorization to provide such information. No response to this email after 2 days will result in the closing of this case. Important Confidentiality Note: This E-mail message may contain privileged or confidential information. The information included in this E-mail is intended only for the person or entity to which it is addressed. Any use of this information by persons or entities other than the intended recipient is prohibited. If you receive this transmission in error, please delete this E-mail and destroy any copies of it.