Start a new topic
Answered

How to perform nozzle Alignment checking

Hi guys,

Please guide me how to perform nozzle alignment checking using Caesar II. Currently I am using following steps to perform alignment check for nozzle. 

1- Defined anchor with C-node having free displacement check. (left blank entries in displacement)

2- Defined WNC load case in load case editor. 

3- Checked displacement results against WNC load. 


Please advise as results are not satisfied able. I need misalignment under 2mm. 



Ayaz

PNG
(77.3 KB)
PNG
(96.9 KB)
PNG
(61.6 KB)

Best Answer

Problem has solved. I have to anchor at least one nozzle in the system, then the results will come out correct. Earlier I did all three nozzles with Cnode having free displacement mode, that's why results were not understandable.


Thanks

1 Comment

Answer

Problem has solved. I have to anchor at least one nozzle in the system, then the results will come out correct. Earlier I did all three nozzles with Cnode having free displacement mode, that's why results were not understandable.


Thanks

Login to post a comment